Independent guide. Not affiliated with, endorsed by, or sponsored by Cricut. Cricut is named only to describe machines and materials.

Updated November 18, 2026

Cricut Explore 3 chipboard settings

Explore 3 publishes light chipboard at 0.37 mm only. Pressure 327, two passes, fine-point blade. Thicker chipboard is a Maker Knife Blade cut.

Explore 3 can use the published preset Light Chipboard 0.37 mm, at cut pressure 327, multi-cut 2x, Fine-Point Blade, on a StrongGrip mat, with no mirror. Chipboard at 1.5 mm and 2.0 mm is not on the Explore 3 list. Those rows need a Knife Blade on a Maker.

Published preset

These rows are for Cricut Explore 3 only. Leave pressure on Default, which is the published cut pressure. Mirror: no. Mat: StrongGrip. Cricut’s mat chart lists chipboard on the strong mat.

Design Space preset

Light Chipboard - 0.37mm

Cut pressure 327

Blade
Fine-Point Blade
Multi-cut
2x
Pressure control
Start on Default
Less Default · 327 More

Default is this published cut pressure. More and Less are the on-screen adjustments if a test cut is off. For a fine-point blade, Custom Materials can also edit the number. The number is Cricut’s Cut Pressure column. It is not pounds or PSI. Copied November 18, 2026 from Cricut’s material list.

Test cut. Cut a small shape on a scrap of the same material before the real project. Cricut says results vary. If the scrap does not cut through, try More, or the next heavier preset that this machine actually publishes. If the blade cuts the mat, try Less. Do not copy a pressure from a different machine.

Measure the board. Most “chipboard” packs at a craft store are closer to 1 mm or 1.5 mm than to 0.37 mm. Explore 3 only has a published row for the thin one.

The preset Explore 3 does have

Search Light Chipboard - 0.37mm. Cut pressure 327. Multi-cut 2x. Fine-Point Blade. The same numbers are on the Explore Air 2 custom list. Maker’s light-chipboard pressure is 285, so do not copy a Maker screenshot onto an Explore 3.

Cricut’s blade guide says a deep-point blade is a good general choice for chipboard, magnet, and foam. The light-chipboard row itself names the fine-point blade. When a preset and a general tip disagree, use the preset for that thickness, and test. A deep-point blade does not turn Explore 3 into a 1.5 mm chipboard cutter. There is still no pressure for that thickness on this machine.

What Explore 3 does not have

Chipboard (1.5 mm) and Heavy Chipboard, 2.0 mm are Knife Blade rows on Maker and Maker 3. Cricut says the Knife Blade’s drive exists only on Maker machines. Explore cannot be upgraded to add it.

Mat and mirror

StrongGrip mat. Do not mirror. Chipboard is not iron-on. Tape the edges if the sheet is smaller than the mat and wants to shift, but do not cover the cut path.

If it tears or stalls

Two passes is already the published multi-cut. If a 0.37 mm scrap still hinges at the corners, try More once. If the blade is scoring the mat, try Less. If the board is thicker than the preset, stop. Forcing more passes on the wrong blade chews the mat and the housing.

See also the Cricut Explore 3 page and the material page.

Sources

Official rows were checked on November 18, 2026. Cricut can change a preset after that date. Open the article before a project you cannot spare.

Questions